GALWAY Pump Specifications

CLICK HOME
	Galway Drum Pump Specifications

Suction Tubes are 1.5 inch OD Schedule 80 pipe, Mixer tube and pump are interchangeable. Standard tube length is 39.5 inch (100cm) Custom lengths from 2 to 8 ft available.
Pumps are a Halar ECTFE two-stage impeller,
Shaft bushings are low friction non-moving carbon-graphite/PTFE
Pump shafts are Hastelloy-C
In-stock pump materials are CPVC, PVDF and Poly. (Halar, FEP or other materials are available upon order)

400 Series Pump Curves:

Model Y Motor	The 1/2 HP at 8000 RPM motor provides a maximum pumping rate of approximately 20 gallons per minute. Shutoff head is about 17 feet (water sg 1.0). The Model Y motor will handle specific gravities up to 1.6 and viscosities over 100 SSU.	Model Y Motor w/ C4-100 Pump
Model W Motor	This 1.1 HP motor at 16,000 RPM provides a maximum pumping rate in excess of 50 gallons per minute. Shutoff head is approximately 40 feet (water sg 1.0) . The Model W motor will handle specific gravities up to 2.0 and viscosities over 1100 SSU.	Model W Motor w/ C4-100 Pump
Model S Motor	The 1/2 HP at 6000 RPM performance provides a maximum pumping rate of about 20 gallons per minute. Shutoff head is approximately 17 feet (water sg 1.0).	Model S Motor w/ C4-100 Pump

Material	CPVC		Polypropylene		PVDF
Model No.	C4-100	Cm-100	P4-100	Pm-100	K4-100	Km-100
Type	Pump	Mixer	Pump	Mixer	Pump	Mixer
Custom pumps may be manufactured to your specifications. Contact us all for availability of materials not listed. All of the above 400 Series Pumps are interchangeable with any Galway Drive Unit.

The specifications contained herin are subject to change without notice and any user of said specifications should verify from the manufacturer that the specifications are current. The manufacturer assumes no responsibility for any use of these specifications. Any warranties exclude normal usage, abuse and misuse. © Galway Pumps 1996